Stand-Off Brackets For S66 Blocks
- Product Resources
Part Numbers
Specification Sheet Library
Installation Instructions
Overview
All of our brackets are designed to create clean, efficient, and space-saving installations when used with S66 connecting blocks. They are open-ended to enable installers to lay in cable before snapping a block into place. 25-pair connectors and/or modular components can be mounted on the sides or back of the brackets. The brackets are molded from flame retardant thermoplastic.
Benefits
- The stand-off brackets (S89D shown) allow cables to be routed behind blocks and provide a means to route cables to the front of the block for termination.
- Technical Tip!
- When mounting blocks end-to-end using SB8-10 brackets, use three brackets for two blocks, four brackets for three blocks and so on.
Part Numbers
- S89B (Picture) Use with M1-25 or M1-50 blocks. Can mount one 25-pair connector on each side.
- S89D (Picture) Use with all M4 X 50 blocks. Can mount two 25-pair connectors on each side and four on the back.
- S89E (Picture) Use with all M4 X 25 blocks. Can mount one 25-pair connector on each side and two on the back.
- S89F (Picture) Use with all M6 X 25 blocks. Can mount one 25-pair connector on each side and three on the back.
- SB6 (Picture) Use with all B6 X 50 series blocks. Can mount three 25-pair connectors on each side and six on the back.
- SB8-10 (Picture) Use for mounting all sizes of S66B blocks.
Because we continuously improve our products, Siemon reserves the right to change specifications and availability without prior notice
Partner Support Center
Share This
Tweet